Cart
-
×
ET Nice Drive 500 Sliding Gate Motor 1 × KSh 61,000.00
-
×
ET Nice Drive 300 Sliding Gate Motor 1 × KSh 52,500.00
Subtotal: KSh 113,500.00
KSh 105,000.00
Centurion Vantage Smart linear motor for domestic and commercial swing gates.
The current price is KSh 105,000. Contact Patsec Security Store to confirm the V300, V400 or V500 model, package contents and installation cost for your swing gate.
The Vantage Smart is a linear actuator system for automating swing gates. It opens and closes the gate leaf through an articulated mounting arrangement and supports compatible phone-based setup and gate controls.
The range is available with 300mm, 400mm and 500mm actuator strokes. The V300 is intended for domestic applications, while the V400 and V500 suit larger domestic or commercial requirements. The correct model depends on gate geometry, leaf length, hinge position and required opening angle.
A single swing gate normally uses one actuator, while a double-leaf gate requires a correctly matched pair and suitable controller. Confirm whether this listing covers one motor or a complete single- or double-gate kit before ordering.
The linear motor is designed for controlled, quiet gate movement. Correct brackets, rigid hinges and accurate mechanical limits are necessary for smooth operation and reliable stopping.
Vantage Smart supports compatible mobile setup for commissioning and system management. Available connected functions depend on the installed controller, accessories and network configuration.
The 12V battery-driven system can complete up to 70 cycles without mains power under stated test conditions. Actual backup performance depends on the batteries, gate size, wind load, mechanical resistance and connected accessories.
A compatible GLX900 mechanical gate lock is recommended for swing gates that need stronger resistance to forced opening. The lock secures the gate physically rather than relying only on the motor to hold the leaves closed.
A complete installation may require infrared safety beams, remote controls, access controls, batteries, cabling, mounting brackets and a compatible gate lock. Safety devices should be positioned and programmed to protect the gate’s opening and closing areas.
The gate leaves should move freely by hand, remain level and use strong hinges and posts. An installer must check the opening angle, available bracket space, wind exposure and the path of each leaf before selecting the actuator and mounting points.
Buy the Centurion Vantage Smart swing gate motor from Patsec Security Store at Accra Road, White Angle House, first floor, shop 76, Nairobi. Contact the store with gate measurements and photos to confirm the correct model and installation requirements.